TeeJet LH 3000 - Manual (Page 8)

LH 3000 OPERATING MANUAL
8 LH A GRO
OPERATION IN GENERAL
All encoding values (basic data) for the calculations are divided in 14 values (1 –
14).
Th encoding values will appear by pressing the “SYSTEM”-key after which the
numerical keyboard will be lit and the values can be encoded.
By repeated press on the “SYSTEM”-key the order of encoding values (1 – 14)
can be leafed through.
A “bip” will sound when a key is pressed during normal operation (not during
encode) and the chosen function will be lit.
If one of the encoded alarm limits is exceeded 3 quick “bip2 will be given
(repeated at intervals) and a displayed error code states alarm type.
ENCODING
All encode value are arranged under the “SYSTEM”-key:
The order of encoding values is:
01 =
Working width in cm.
02 = Wheel circumference in cm.
03 = Flow figure.
04 = Boom sections.
05 = Choice of speed sensor.
06 = Warning limit application rate.
07 = Warning limit pressure.
08 = Warning limit rpm
09 = +/- change of application rate
10 = Time factor (automatic dosage).
11 = Uniform pressure
12 = Metric/Imperial
13 =
Choice of implement sensor
14 = Printer
By means of the “SYSTEM”-key it can be leafed through the order of the above
values, step by step.
The encoding is ended by pressing the “SYSTEM”-key for 3 seconds, whereever
in the order you are.
LH 3000 automatically deletes the “old” encoding value when the encoding is
started.