TeeJet LH 3000 - Manual (Page 21)

LH 3000 OPERATING MANUAL
LH AGRO 21
CLEAR
The “clear” key is used for deleting any encoding and works almost like the c-key
of a pocket calculator. Used for deleting encode of faulty figures.
Besides the key is used for zeroing of total counters (flow + area).
EXAMPLE: Zeroing of “area”:
1. Press and simultaneously until the display is blank.
2. The area counter is now zeroed.
NB! The “CLEAR” key and the “MEMO” key are also used together for deleting
the memory. First press "MEMO" and then "CLEAR" and keep them
pressed simultaneously until the display shows "CLEAR".
PRINT
Print of stores memory is started by pressing the "PRINT"-key.
EXAMPLE:
1. Connect printer
2. Press . The display will show "PRINT" and the last stored
card will be printed.
Are all job cards required printed do as follows:
3. Press for 3 seconds. The display will show "ALL" and all stored
cards will be printed.
NOTE: If print of all cards has been started the printer cannot be stopped until the
memory is empty.
Select of printer type is done in ENCODE point 14.
SYSTEM
The "SYSTEM" key is the key for "ENCODE". Only if programmed data, say
working width, should be changed, operation of this function will be needed. See
also page 8.