TeeJet 844-R Speed Compensated Application Control - Manual (Page 26)

26 98-05047
R0
Pressing the
P
RO
key again will take you back to the pressure calculation step.
Known Pressure Calculation
Adjust the pressure value to the desired operating pressure and the speed value will
automatically change to reflect the approximate speed required to achieve the
programmed target rate at the pressure selected. This gives an indication of the speed
range expected at the desired operating pressure range.
Use the
+
or keys to adjust this
value.
The console immediately determines
what the operating speed should be to
achieve the target application rate at this
pressure.
If the speed indicated is too high, a set
of smaller orifices or Micro-Tubes is
needed.
If the speed indicated is too low, a set of
larger orifices or Micro-Tubes is needed.
Press the
P
RO
key to advance to the speed calculation step.
Continue to try different speed, pressure and tip combinations. Once the correct
setting is determined:
Exit the Application Preset Mode by pressing and holding the
P
RO
key for 2
seconds.
Daily Flow Meter Maintenance
√ Remove flow meter from the system
√ Use a soft bristle brush to scrub the tube clean
√ Use clean water to wash any impurities out of the flow meter
√ Reinstall flow meter
2 0.0
GPA
12
6.0
0.019 MPH
PSI