TeeJet 844-R Speed Compensated Application Control User Manual
Page 25

98-05047
25
R0
F
LOW
R
ATE
S
ELECTION
Next, the tip icon in the top section of the display starts flashing. This value
represents the flow capacity of a single orifice or Micro Tube in Gallons Per
Minute (GPM) at 12 PSI. Using flow capacity information from the manufacturers
documentation, set this to the correct value.
Use the
+
or keys to change
the value.
Press the
P
RO
key to advance to the
next step
C
ALCULATION
S
TEPS
The following two steps are calculation or informational steps only. They have no effect
on the application or operation of the console.
Known Speed Calculation
Adjust the speed value to the desired application speed. The pressure value
automatically adjusts to the approximate pressure required to apply the desired
application rate at the speed selected. This allows the opportunity to be sure the
application values are in the range expected prior to the actual application.
Use the
+
or keys to adjust
the indicated speed to a value
that you will be traveling at.
The console immediately
calculates what the pressure
should be to maintain the target
application rate at this speed.
If the pressure is too high,
substitute a larger set of orifices
or Micro-Tubes, or slow down.
If the pressure is too low, substitute a smaller set of orifices or Micro-
Tubes, or speed up.
GPA
2.0
12
6.0
0.019
MPH
PSI
GPA
2.0
12
6.0
0.019
MPH
PSI