TC-Helicon VoicePro - Manual (Page 63)

63
Section 6: Detailed Parameter Descriptions
MIX
To facilitate the creation of complete presets, VoicePro
contains a full featured mixer. Mix is based around a
traditional mixer. Vertical strips are used for each overall
VoicePro block. Each block then contains typical mixer
controls like sends, pans, levels, etc.
Dry Lead
This is the voice input signal through Dynamics and EQ
inserts.
VirtuaLead
This is the output of the Dry Lead signal after going
through Time, Pitch & Character.
Harmony
This is the stereo mix output of the Harmony Block.
Overall FX
Controls the overall level of µMod, Delay and Reverb
µMod, Delay, Reverb
Controls stereo output level of the respective blocks
Aux Input
This is the signal present at the Aux Input which can not be
routed through Harmony or VirtuaLead.
Sends
The effects sends for Dry Lead, VirtuaLead, Harmony, Aux
Input are configurable pre or post fader.
Pan / Width
The mono blocks Dry Lead, VirtuaLead, and Aux Input
have standard pan controls to set stereo position. The
stereo blocks have width controls that range from full
stereo to mono.
BROWSER
The Browser is your starting point for finding a vocal
sound. There are three filters on the Browser page to help
choose the right preset. Use the Scroll Wheel to preview a
preset. Press the OK Button to load the selected preset.
Source Filter
VoicePro can show presets intended for "Singing" or
"Speaking" voices. When "All" is selected, all presets are
shown based on the other filter settings.
Application Filter
Each preset is assigned an application. VoicePro contains
11 application types: Correction, Doubling, Harmony,
Classic FX, Special FX, Character, Pitch & Time,
Transducer, Live, Other. The Harmony application can also
be filtered by the Harmony Mode.
Type Filter
Type allows "All", "Factory" or "User" presets to be shown.
Additionally, the presets can be browsed alphabetically
instead of sequentially.