TC-Helicon VoicePro - Manual (Page 25)

25
Section 3: Music Applications
Working with Classic FX
In VoicePro, the effects that are termed "classic" are
created using the µMod, Delay and Reverb blocks. The
resulting effects include:
• Reverb
• Reverb with ducking
• Delay
• Delay with ducking
• Tap Tempo Delay
• Chorus
• Flange
• Stereo detuning
• Combination sounds (Reverb & Delay, etc.)
The Reverb and Delay effect blocks perform their named
functions, and the µMod (micromod) block performs the
Chorus, Flange, and Stereo Detuning functions. Each block
has a number of pre-programmed styles to allow fast
access to a number of interesting and useful effects without
parameter editing. Of course, you can edit the styles and
store the changes with the preset.
How to load a Classic FX preset
1.Navigate to the browser and set the Source Filter to
“Singing” and the Application Filter to “Classic FX”, then
select a preset using the Scroll Wheel and Ok Button.
How to enable classic effects in a preset
1. Press the Matrix Button.
2. Press the Up or Down Arrow Buttons to highlight the
Multi-FX row.
3. Turn the appropriate Soft Knobs clockwise to enable the
effects desired.
4. If you hear no effects even though audio input is
present, press the Mix Button.
5. Use the Right or Left Arrow Buttons to scroll the screen
so that you can see the effects send levels at the top of
the screen. These are usually set at nominal send
settings in the Factory presets but you can adjust them if
needed using the Arrow Buttons and Soft Knobs.
6. Use the Arrow Buttons to reveal the effects return levels
at the bottom of the screen. These are usually set at
nominal send settings in the Factory presets but you can
adjust them if needed using the Arrow Buttons and Soft
Knobs.
How to mute the classic effects in a preset
1. Press the Matrix Button.
2. Press the Up or Down Arrow Buttons to highlight the
Multi-FX row.
3. Turn the appropriate Soft Knobs counter-clockwise to
mute any effects enabled in the preset.
4. Press Store twice if you want to save the change to the
preset.
5. Press the Home Button.
How to edit the classic effects
1. Follow the previous instructions to enable the desired
effects block in the Matrix and to confirm signal routing is
correct in the mixer.
2. Press the Multi-FX Button to access the effect editing
parameters.
3. Press the Right or Left Arrow Buttons to locate the tab
containing parameters for the effect you want to edit e.g.
Reverb.
4. Use the Up and Down Arrow Buttons to locate the Edit
row containing the Style Parameter.
5. Turn the appropriate Soft Knob to change to the desired
style.
6. If further editing is required, you can edit all parameters
using a combination of the Up and Down Arrow Buttons
and the Soft knobs.
7. Press Store twice to save edits with the preset.