Sonics X-Press Integrated Welder - Manual (Page 30)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L X - P R E S S
29
M A I N T E N A N C E
REPAIRS / SERVICE
If problems are encountered, contact our Service Department as follows:
Phone: 1-800-745-1105 • 1-203-270-4600 ext. 343 or 366
Fax: 1-203-270-4610
E-Mail: service@sonics.
com
It is suggested that a system in need of repair be sent back to the factory,
with a written description pertaining to the nature of the problem.
Always contact the factory for return authorization before shipping any
instrument. Include date of purchase, model number, and serial number. For
units not covered by the warranty, a purchase order should be forwarded to
avoid unnecessary delay. Care should be exercised to provide adequate
packing to insure against possible damage in shipment. The system must be
sent with all transportation charges prepaid and return method of shipment
indicated.
DRAINING THE AIR FILTER BOWL
Periodically check the Air Filter Bowl for any moisture and/or condensation,
and drain as necessary.
To drain, simply unscrew the knurled brass fitting at the bottom of the bowl.
Drain any collected moisture, and then replace the fitting.
NOTE: If packing unit for
return shipment, DO NOT
use styrofoam “peanuts.”
AIR FILTER
BOWL
KNURLED
FITTING
Go To Top Of Document