Sonics X-Press Integrated Welder - Manual (Page 27)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L X - P R E S S
26
O P E R A T I O N
ACTUATION
The press is equipped with two maintained anti-repeat (non-tie-down) palm
buttons, one located on the left and one on the right side of the base of the
press. Both palm buttons must be pressed simultaneously to activate the
press to cycle the welder. To operate the press, follow these simple steps:
1. Depress both black palm buttons simultaneously.
2. Once the horn comes in contact with the part, the pressure switch closes
and the ultrasonics are activated, release the palm buttons. If you release
the buttons before contact is made, the head will immediately return to its
“home” position.
EMERGENCY STOP
To abort the press during welding, simply press the red EMERGENCY STOP
button located at the front center of the press base.
Once the EMERGENCY STOP button has been depressed, the head will
retract and return to its “home” position. Simply rotate the EMERGENCY
STOP button clockwise 1/4 turn to release the press for further operation.
NOTE: Power cannot be
shut off once the weld
cycle has started.
Termination of cycle can
only be achieved by using
the EMERGENCY STOP
button.
The equipment has safety
devices that require both
hands to be on the palm
buttons until the horn
contacts the workpiece. Do
not defeat or modify
these safety devices.
Do not use with a
footswitch unless alternate
means of pinch-point
protection is provided.
Go To Top Of Document