Connections – Sonics X-Press Integrated Welder User Manual

Page 11

KEY COMPONENTS

CONNECTIONS

When making initial air supply or impulse cable connections, make sure all

electrical power is disconnected. Located on the connection plate at the

base of the press head are the following:

1. Connect the air supply source to the press air hose.

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

I N S T R U C T I O N M A N U A L • M O D E L X - P R E S S

NOTE: Do not strain or kink

cables. When going around

corners, allow as wide a

bend as possible. Do not

run cables parallel to any

power line within a

distance of less than 1 foot

(304.8mm).

CONVERTER HOUSING
with converter, booster &
horn (stack) assembly

PALM BUTTONS

CONVERTER
HOUSING DOOR

EMERGENCY STOP
BUTTON

PRESSURE GAUGE
REGULATOR

HEAD DOWN SWITCH

SPEED CONTROL KNOBS

CONNECTION
PLATE

AIR CONNECTION

Power input,
hardwired cable.

Base/impulse cable.

Line Fuse (based on
requirements listed in “Power
Specifications" table, page 9).

Fuse (0.5 amp - internal low
voltage).

MICROPROCESSOR
CONTROLS

Go To Top Of Document