Sonics X-Press Integrated Welder - Manual (Page 12)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L X - P R E S S
11
2. If you are using an impulse cable, connect it as noted above (disconnect
the base cable if necessary). Refer to the Impulse Cable drawing in the
Appendix, page 36.
3. When the above connections are secure, the power line cord can be
plugged into an appropriate electrical outlet.
4. To prevent the possibility of an electrical shock, ensure that the power
supply line cord is properly grounded. Also make sure that the voltage
rating of the electrical power source matches the press power
requirement (refer to the “Power Specifications” table on page 9).
5. Check with your electrician if you have any wiring questions.
Go To Top Of Document