Solvline Eddy DK Ver 2.20 - Manual (Page 72)

Chapter 9. Appendix
9-6
Once the recovery is done, use “boot” command start booting.
Registering Mac address
Once it has been recovered, login screen is displayed. Now type in ID and password as you would access to telnet.
Then register deleted Mac address. Input command for Mac address is “def mac xx:xx:xx:xx:xx:xx”
It can be saved by “def save” command. Reboot after saving
Mac address is printed at the label attached on top of the product.
The following shows example of Mac address “00:01:02:03:04:05”.
Recovery will be done by following above steps. Should there have been any problem during recovery, see the next
page.
U-Boot> boot
## Booting image at 20000000 ...
Image Name: eddy-os-20a.img
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1112220 Bytes = 1.1 MB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
OK
## Loading Ramdisk Image at 20500000 ...
Welcome to the Eddy development environment.
Eddy login: eddy
Password:
#
def mac 00:01:02:03:04:05
# def save
# def view
Flash Write Successfully
# def view
============< Welcome to Eddy Configuration Manager >==============
BootLoader Version : 2.0a
Kernel Version : 2.0a
Fimeware Version : 2.0a
-------------------------------------------------------------------
Device Type : Eddy-CPU
Device Name : Eddy
Username : eddy
Password : 99999999
MAC Address : 00:05:f4:7a:11:04
Network Line : Static IP
:
:
===================================================================
# reboot