3 example cgi code, 3 example cgi code -2 – Solvline Eddy DK Ver 2.20 User Manual
Page 64
Chapter 8. Handling HTML & CGI
8-2
" value="[v,
n_dns
]" >
As shown above there are name and value part for each record to link with CGI.
Name stores information modified by user in HTHM so that it can save modified value when the user click
on submit button at the lower part of HTML page. Value reads value to getagent.c to display on HTML page
and lets user to modify the value she or he wants.
8.3 Example CGI Code
Eddy-Serial DK has two CGI programs: getagent.cgi and setagent.cgi.
“getagent.c” reads /etc/sb_config file to HTML document to display configuration information, and “setagent.c”
saves user-modified information from HTML document back to /etc/sb_config file and ultimately saves to
flash/sb_config so the user-modified environment configuration information is stored even if Eddy is reset.
The following example shows processing part of getagent.c to display configuration value HTML page of example
above.
[Source abstract]
if
(cgiFormStringNoNewlines("
N_IP
", buff, 16) == cgiFormNotFound)
{
sprintf(buff,
"%d.%d.%d.%d",cfg.system.ip[0],
cfg.system.ip[1],cfg.system.ip[2],cfg.system.ip[3]);
listPutf(list, "
n_ip
", buff);
}
else
listPutf(list,
"
n_ip
", buff);
if
(cgiFormStringNoNewlines("
N_MASK
", buff, 16) == cgiFormNotFound)
{
sprintf(buff, "%d.%d.%d.%d",cfg.system.mask[0], cfg.system.mask[1],
cfg.system.mask[2],cfg.system.mask[3]);
listPutf(list,
"
n_mask
", buff);