Solvline Eddy DK Ver 2.20 - Manual (Page 18)

Chapter 2. Getting Started
2.4 Hardware installation
2.4.1 Eddy-CPU Installation
Place Eddy CPU module firmly on to Eddy-DK board as shown above.
Connect LAN cable to the LAN port.
Connect DB9 serial cable to COM 1, COM2, and Debug Port.
Configure Product Setting Switch1 to Eddy-CPU mode (Please see 2.3.2.2. Product Setting Switch )
After checking that the input power is 5 V, supply the power to the Eddy-DK board.
Check the Power LED condition to make sure the operation is normal.
If Eddy CPU module is in initialized state, all GPIO LEDs should be ON. If all LEDs are not
ON, check and see whether GPIO and Product Setting Switch settings are set properly.
2-10