beautypg.com

Operation – SeaLand 976 Portable Toilets User Manual

Page 3

background image

3

MSD Models: Pull flush handle to open flush valve . Pump out holding tank through
boat’s discharge fittings according to boat manufacturer’s instructions .

Prepare toilet for use

1 . CAUTION! With seat lid closed, pull

flush handle to open slide valve, then

push to close. This relieves air pressure

that may be created in lower holding

tank due to changes in temperature or

altitude.

2 . Remove water cap and fill upper tank until

it reaches about 1 inch (25 mm) below

opening . Replace cap .

3 . Pull flush handle to open slide valve .

4 . Pour deodorant directly into lower tank,

then close slide valve .

CAUTION! Never pour deodorant into

bowl with slide valve closed.

5 . Stroke air pump about 15 times or until air

emits through relief valve on water cap .
CAUTION! Do not over-pressurize

upper tank by covering relief valve.

Do not pressurize upper tank when

disconnected from lower tank.

oPeratioN

Use toilet

1 . CAUTION! BEFORE EACH USE, with

seat lid closed, pull flush handle to open

slide valve, then push to close. This

relieves air pressure that may be created

in lower holding tank due to changes in

temperature or altitude.

empty holding tank
1 . When tank level indicator shows “full,”

empty the lower tank .

2 . Pull up on rear latch to separate upper tank

from lower tank . Carry lower tank to autho-

rized waste disposal area (or normal toilet) .

2 . Pull flush handle to release waste into

lower tank .

3 . Push flush button to rinse bowl . Push flush

handle to close slide valve .

3 . Rotate discharge spout away from tank,

and open vent on top of holding tank .

Empty tank .

4 . If water is available, rinse lower tank before

reassembling portable toilet .