Reznor DV Operation Manual (for units built before August 2003) - Manual (Page 6)

Form O-DV/RDF/ADF, P/N 148385, Page 5
FIGURE 4 - Burner End
Plate showing Hot Surface
Ignitor
Flame Sensor
(not shown)
Location
Burner
End Plate
burner body. The gaskets are
designed to overlap approxi-
mately 1/16" for airtight seal.
5) Follow Steps in reverse
order to re-install the pilot
assembly. Close all panels
and check for proper
operation.
NOTE: Model RDF units
manufactured prior to 3/96
have a spark ignition system.
Clean ultraviolet sensor and
spark plug. Replace as
needed.
WARNING: Burner
profile plates are
factory set to match
CFM requirements. Do
not adjust profile plates
without contacting your
Sales Representative
for technical assistance.
FIGURE 5 - Direct Fired
Burner
7. Optional
Evaporative
Cooling Module
(ADF/ADFH only)
Media - Over time, excessive amounts of mineral deposits will begin to buildup
on the media. Annually, scale and dirt should be washed off the entering sur-
face of the media. Remove the pad retainers and screen. (See Steps 1-3 and 6-
8 of Media Replacement Instructions.) Clean the media using a garden hose,
mild soap, and a soft bristled brush. When the media becomes too clogged
with mineral deposits and dirt that it cannot be cleaned, the pads should be
replaced. The average pad life is approximately three cooling seasons.
Select the correct replacement part numbers and order media pads from your
Distributor. Follow the instructions below and remove and replace pads as
shown in FIGURE 6.
R E
Instructions for Replacing
Evaporative Cooling Media
1. Remove the three sheetmetal screws that hold the top pad retainer in
place. Release the top pad retainer from the cooling module.
2. Remove the three sheetmetal screws that hold the bottom pad retainer in
place. Release bottom pad retainer from the cooling module.
3. Disengage the screen retainers from the sides of the media.
4. Disengage inlet screen from media pads and remove.
5. Slide all media pads horizontally away from the cooling module until
clear of bottom reservoir pan. Dispose of properly.
Replacement Part No. (each)
Cellulose Fiber Glass Fiber
(inches) Qty 6" 12" 6" 12"
300 24 x 12 2 105985 106021 106037 106029
24 x 7-7/8 1 105986 106022 106038 106030
500 24 x 12 3 105985 106021 106037 106029
24 x 9-5/8 1 105989 106025 106041 106033
700/ 48 x 12 4 107190 107194 107199 107201
1200 48 x 8-5/8 1 107191 107195 107200 107202
ADF /
ADFH
Media Pad
Sizes
Ignitor
Mixing
Plates
Burner - Full length of the
burner is made up of a series
of 6" or 12" burner sections in
a linear or oval configuration.
Burner
End Plate
Pilot Tubing