Rev-A-Shelf 4WP Series User Manual
4wp series installation instructions, Swing out unit, 25" tall version shown)

4WP Series
Installation Instructions
Step 1. Set Swing Out unit in cabinet with
3/4" spacer underneath for floor clearance.
Step 2. Swing Piano Hinge around to inside of
cabinet where unit is to be installed.
Step 3. Place the 1/4" spacers between unit and
center divider of cabinet. One at top and
bottom of unit
1/4" Spacer
Center Divider
Piano Hinge
Swing Out Unit
• Swing Out Unit
(25" tall version shown)
Over
Contents
1- Pantry Unit with Piano Hinge
1- Magnetic Catch and Strike Plate
4-Wire Fence pieces for top shelf (if needed)
8 - Wood plugs for top shelf (if wire fence is not used)
2- 1/4" spacers
1-Screw pack
Items needed for installation
Phillips Head Screw Driver
3/4" wood spacer
Note: If adequate clearance is available, install top shelf
wire fencing. If clearance is not available install
wood plugs into holes
Top View
- 445-VCG20-8 (2 pages)
- 448-VC20-8 (2 pages)
- VIB-20CR (2 pages)
- COSK-18 (2 pages)
- 432 Series (2 pages)
- 4WH-RM-15DM-1 (2 pages)
- HPRV-1520 S (2 pages)
- HURV-1512 S (2 pages)
- 4VHTM-1520DM-1 (2 pages)
- SBVDT-2124-S-1 (8 pages)
- 6882-31-15-570 (4 pages)
- 4WLS882-32-570 (1 page)
- CAG-081642-1 (2 pages)
- CBSR-Series (4 pages)
- BRC-Series (2 pages)
- CWTBR-Series (2 pages)
- CWSBR-Series (2 pages)
- CJD-2414-R (2 pages)
- CVJD-Series (2 pages)
- 5190-15RM-117 (2 pages)
- CH-241419-RM-217 (2 pages)
- CTOHB-Series (1 page)
- CM-1448-ORB-1 (2 pages)
- PSC-Series (8 pages)
- CPDR-Series (2 pages)
- CLSZ-M5-96-1 (2 pages)
- CSPD-6 (1 page)
- SHR-3684 (1 page)
- TRC-Series (2 pages)
- CWTTR-Series (2 pages)
- CWSTR-Series (2 pages)
- 6273-20-XXX (2 pages)
- 6260-XXX (2 pages)
- 4WLS273-20-536 (2 pages)
- I-WOOD 11-05 (2 pages)
- 6072-Series (2 pages)
- 3073-Series (2 pages)
- LD-4BW-472-XXX (2 pages)
- 5472-28 CR (1 page)
- LD-2942-28-15-1 (4 pages)
- 6942-Series (2 pages)
- 4-WLS-MAT-XXX (1 page)
- 4-NW-MAT-XXX (1 page)
- 4KCB-Series (1 page)
- 4WTCD-Series (2 pages)