Cabletron Systems ESX-1380 - Manual (Page 52)

Chapter 8: The Bridge Setup Screen
8-4 ESX-1320/ESX-1380 Local Management Guide
8.4 SELECTING BRIDGE PORT PAIR
ADMINISTRATIVE STATUS
To select the bridge port pair administrative status, perform the following
steps:
1. Use the arrow keys to highlight the [BRIDGE_PORT X] field.
2. Press SPACE bar or BACKSPACE to select the bridge port you want
to configure. The selected bridge port appears in the Bridge Port Pair
Admin Status field.
3. Use the arrow keys to highlight the BRIDGE PORT PAIR ADMIN
STATUS: PORT X - -> PORT [Y] field.
4. Press SPACE bar or BACKSPACE to select the port you want to
enable or disable bridge traffic.
5. Use the arrow keys to highlight the BRIDGE PORT PAIR ADMIN
STATUS: PORT X - -> PORT [Y] [ENABLED] field.
6. Press SPACE bar or BACKSPACE to select ENABLED or
DISABLED.
For example, the following bridge setup indicates that bridge port 01
is configured NOT to bridge traffic to bridge port 02:
BRIDGE PORT PAIR ADMIN STATUS: PORT 01 - - > PORT [02]
[DISABLED]
7. Use the arrow keys to highlight the SAVE command field.
8. Press ENTER. The Event Message field at the top of the screen
displays “SAVED OK”.