beautypg.com

Rv-series, Pull-out waste containers and hampers, Installation instructions for – Rev-A-Shelf HPRV-1520 S User Manual

Page 2

background image

I-RV-09

©2009 Rev•A•Shelf, Inc. • 12400 Earl Jones Way Louisville, KY 40299 • 1-800-626-1126

Votre Série RV a été livrée complètement montée pour faciliter son installation.

• D’abord, enlever la (les) poubelle(s) du châssis en fil d’acier.

• Placer le châssis à l’intérieur de votre cabinet.

• Vérifier qu’il y a suffisamment de place pour fermer la porte et pour accommoder la

poubelle.

Su Serie RV ha sido completamente montado de antemano para facilitar su instalación.

• Primero, hay que sacar el cubo o los cubos del chasis en hilo de acero.

• Colocar el chasis al interior de su gabinete.

• Verificar que hay espacio suficiente para cerrar la puerta y para el cubo de basura.

Avec le châssis en position fermée, installez les deux vis de devant, prenant soin de positionner

le châssis en équerre par rapport au devant du cabinet.

Con el chasis en la posición cerrada, instalar los dos tornillos de delante, cuidando de colocar el

chasis bien cuadrado con respecto al borde delantero del gabinete.

S’il y a suffisamment de place, installez les vis de derrière.
Au cas où le châssis ne permettrait pas l’accès aux vis de l’arrière, enlever le châssis en le

soulevant pour le sortir des glissières.

Note: si votre unité est équipée de glissières complètement extensibles, il faut d’abord dégager les

dispositifs de fermeture avant d’enlever le châssis (Figure A). Pressez un levier vers le haut et l'autre levier

vers le bas. Finalement, placer la poubelle dans le châssis en fil d’acier et votre installation est terminée.

Si hay espacio suficiente, instalar los tornillos traseros.
En el caso de que el chasis no deje acceso a los tornillos traseros, remover el chasis con jalarlo

hacia arriba para sacarlo de los rieles.

Nota: si su unidad está equipada de rieles completamente extensibles, primero hay que soltar los

dispositivos de cierre antes de sacar el chasis (Figura A). Presione la una palanca para arriba y la otra

palanca abajo. Finalmente, colocar el cubo de basura en el chasis en hilo de acero y su instalación ya está

terminada.

Au cas où vous auriez des questions ou vous voudriez recevoir des renseignements supplémentaires sur nos autres produits pour cuisine, placards ou salle

de bains, veuillez appeler nos Spécialistes au Service Clients au 1-800-626-1126 ou aller à notre site www.rev-a-shelf.com. Aussi, ne pas oublier notre kit pour

monter sur porte qui permet d’attacher votre porte de cabinet poubelles de dèchets et paniers à linge à glissières extensibles de la Série RV à la Poubelle RV.
Si Usted tiene cualquier pregunta o si quiere recibir más detalles sobre nuestros otros productos para la cocina,

los armarios o el cuarto de baños, por favor llame a nuestros Especialistas al Servicio de los Clientes al 1-800-626-

1126 o visitar nuestro sitio en la red al www.rev-a-shelf.com. También, no hay que olvidar nuestro kit para montar

en la puerta que permite fijar su puerta de gabinete cubo de basura y cestas para ropa montado sobre rieles

extensibles de la Serie RV al cubo de basura RV.

Instructions d’Installation pour: Poubelles de dèchets et paniers à linge à glissières extensibles de la Série RV

Instrucciones de Instalación para:

Cubo de basura y cestas para ropa montado sobre rieles extensibles de la Serie RV

1

2

3

FIGURE A

1

1
2

3

3

Note: Le Panier HPRV comprend une attache de soutien qui s’attache à l’arrière du panier. Il faut juste glisser cette

attache sur le panier sur la rangée de trous du bas.
Nota: La cesta HPRV incluye un clip de retención el cual se sujeta a la parte posterior de la cesta. Simplemente deslice

este clip en la cesta en la parte inferior de la fila con agujeros.

Installation Instructions for:

RV-Series

Pull-Out Waste Containers and Hampers

With the frame in a closed position, insert the front two

screws, making sure that the framework is square to the

front of the cabinet.

If there is sufficient clearance, install rear screws.
If framework prevents access to rear screws, remove

framework by pulling out and lifting frame from slides.

Note: if your product features full extension slides

remove frame by disengaging release triggers (Fig. A).

Finally, place your waste container in the wire frame and the

installation is complete.

Your RV series has been shipped fully assembled for ease

of installation.

• First Remove the container(s) from the wire frame.

• Place the frame inside of your cabinet.

• Look to make sure that there is plenty of clearance to

shut the door and for the waste container.

I-RV-05

©2005 Rev•A•Shelf, Inc. • 2409 Plantside Drive • Jeffersontown, KY 40299 • 1-800-626-1126 • FAX 502-491-2215

If you have any questions or would like additional information

r

o

,t

e

s

o

l

c

,

n

e

h

c

ti

k

e

h

t

r

o

f

s

t

c

u

d

o

r

p

r

u

o

f

o

t

s

e

r

e

h

t

n

o

bathroom, please contact a Customer Service Specialist at:

1-800-626-1126 or visit us on the web at www.rev-a-shelf.com.

Also, don't forget about our door mount kit

that will attach your current cabinet door to your RV Waste

Container or Hamper.

1

2

3

NOTE: The HPRV Hamper includes a

retaining clip which attaches to the rear of

the hamper. Simply slide this clip onto the

hamper on the bottom row of holes.

NOTE: The HURV Utility basket includes

a retaining clip which attaches to the rear

of the basket. Simply center this clip on

the third row from the bottom and bend

retaining clips down to

keep clip in place.

Retaining Clip

Retaining Clip

Installation Instructions for:

RV-Series

Pull-Out Waste Containers and Hampers

With the frame in a closed position, insert the front two

screws, making sure that the framework is square to the

front of the cabinet.

If there is sufficient clearance, install rear screws.
If framework prevents access to rear screws, remove

framework by pulling out and lifting frame from slides.

Note: if your product features full extension slides

remove frame by disengaging release triggers (Fig. A).

Finally, place your waste container in the wire frame and the

installation is complete.

Your RV series has been shipped fully assembled for ease

of installation.

• First Remove the container(s) from the wire frame.

• Place the frame inside of your cabinet.

• Look to make sure that there is plenty of clearance to

shut the door and for the waste container.

I-RV-05

©2005 Rev•A•Shelf, Inc. • 2409 Plantside Drive • Jeffersontown, KY 40299 • 1-800-626-1126 • FAX 502-491-2215

If you have any questions or would like additional information

r

o

,t

e

s

o

l

c

,

n

e

h

c

ti

k

e

h

t

r

o

f

s

t

c

u

d

o

r

p

r

u

o

f

o

t

s

e

r

e

h

t

n

o

bathroom, please contact a Customer Service Specialist at:

1-800-626-1126 or visit us on the web at www.rev-a-shelf.com.

Also, don't forget about our door mount kit

that will attach your current cabinet door to your RV Waste

Container or Hamper.

1

2

3

NOTE: The HPRV Hamper includes a

retaining clip which attaches to the rear of

the hamper. Simply slide this clip onto the

hamper on the bottom row of holes.

NOTE: The HURV Utility basket includes

a retaining clip which attaches to the rear

of the basket. Simply center this clip on

the third row from the bottom and bend

retaining clips down to

keep clip in place.

Retaining Clip

Retaining Clip

Installation Instructions for:

RV-Series

Pull-Out Waste Containers and Hampers

With the frame in a closed position, insert the front two

screws, making sure that the framework is square to the

front of the cabinet.

If there is sufficient clearance, install rear screws.
If framework prevents access to rear screws, remove

framework by pulling out and lifting frame from slides.

Note: if your product features full extension slides

remove frame by disengaging release triggers (Fig. A).

Finally, place your waste container in the wire frame and the

installation is complete.

Your RV series has been shipped fully assembled for ease

of installation.

• First Remove the container(s) from the wire frame.

• Place the frame inside of your cabinet.

• Look to make sure that there is plenty of clearance to

shut the door and for the waste container.

I-RV-05

©2005 Rev•A•Shelf, Inc. • 2409 Plantside Drive • Jeffersontown, KY 40299 • 1-800-626-1126 • FAX 502-491-2215

If you have any questions or would like additional information

r

o

,t

e

s

o

l

c

,

n

e

h

c

ti

k

e

h

t

r

o

f

s

t

c

u

d

o

r

p

r

u

o

f

o

t

s

e

r

e

h

t

n

o

bathroom, please contact a Customer Service Specialist at:

1-800-626-1126 or visit us on the web at www.rev-a-shelf.com.

Also, don't forget about our door mount kit

that will attach your current cabinet door to your RV Waste

Container or Hamper.

1

2

3

NOTE: The HPRV Hamper includes a

retaining clip which attaches to the rear of

the hamper. Simply slide this clip onto the

hamper on the bottom row of holes.

NOTE: The HURV Utility basket includes

a retaining clip which attaches to the rear

of the basket. Simply center this clip on

the third row from the bottom and bend

retaining clips down to

keep clip in place.

Retaining Clip

Retaining Clip

Nota: La cesta de utensilios HURV incluye un clip de retención el cual se sujeta a la parte trasera

de la cesta. Simplemente centre este clip en la tercera fila de la parte inferior y doble el clip de

retención hacia abajo para mantenerlo en posición.

Note: Le Panier Utilitaire HURV comprend une attache de soutien qui s’attache à l’arrière du panier.

Il faut juste centrer cette attache sur la troisième rangée à partir du bas et plier les attaches de

soutien pour les maintenir en place.

Attache de Soutien

Clip de retención

Attache de Soutien

Clip de retención