Rev-A-Shelf RAS-CIB COVER-R-52 - Manual (Page 2)

Step 6. With both slides full closed and inside the cabinet, apply the double-sided tape to the front of the slide flanges.
use a small spacer in the friction slide assembly as shown if needed
to insure that cross braces are horizontal, and parallel.
Cross braces MUST be parallel and horizontal
Step 7. CAREFULLY line up your drawer front, and “stick” it to the front of the slides with the
supplied double-sided tape. You can now carefully pull on the drawer head to open the drawer.
Once slightly open it is recommended to pull on the slides not the drawer. Attach the drawer
head to the slides with (8) of the provided #8 flathead screws.
Step 8. With drawer front attached re-install the board, support brackets,
and mechanism into the drawer being sure to have the front wire support
held in place on the drawer front by the support brackets. Also insure that
the bolt heads are on the BOTTOM of the unit. This is critical due to the
tight fit of this product.
Re-install nuts on top for clearance
Front wire support
Support Bracket
Step 9. Use (4) #8 flathead screws
to attach the support brackets to
the drawer front.
Step 10. Fold then slide board into drawer, and check for proper operation, and make any adjustments necessary.
Operation Instructions
Lift and release latch on bottom side of board before folding board back into closed position.
Make sure board is fully closed, and lift drawer head before pushing board back into cabinet.
Questions? Call our Customer Service Specialist at
800-626-1126 or visit us online at www.rev-a-shelf.com
2409 Plantside Drive
Jeffersontown, KY 40299 I-IB-1008