Routine maintenance, Replacing lamp – PRG AutoPar User Manual 2.1 User Manual
Page 38
30
AUTOPAR
®
WASH LUMINAIRE USER MANUAL
ROUTINE MAINTENANCE
Replacing Lamp
Parts:
71.2566.0700.0
LAMP, MSR 700W
Tools:
#2 Phillips Screwdriver
WARNING:
Remove power from luminaire before performing any maintenance procedures.
CAUTION:
Wear cotton gloves or other covering while installing lamp. Touching lamp glass with bare
fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use alcohol and
cotton cloth to thoroughly clean glass portion of lamp.
To replace lamp:
Step
1. Remove power from luminaire and allow lamp to cool.
Step
2. At backcap, remove four tamper-proof screws and lock washers (Figure 4-1).
Step
3. Pull backcap straight back and out of head assembly.
Step
4. Gripping lamp at base, remove from socket.
Step
5. Install new lamp.
Step
6. Reset lamp hours as required. Refer to
Step
7. Align lamp according to procedure on next page.
Figure 4-1: Replacing Lamp
CAUTION:
Do not touch lamp or
reflector with bare fingers.
CAUTION:
Allow lamp to cool
before servicing.
Lamp
Backcap
Tamper-Proof
Head Assembly
Screw (4)
Luminaire Yoke Not Shown For Clarity
#6 Int. Tooth
Lock Washer (4)