PRG AutoPar User Manual 2.1 - Manual (Page 14)

6 AUTOPAR ® WASH LUMINAIRE USER MANUAL
Major Components and Controls
The following illustration shows the external luminaire components and controls.
Figure 1-2: AutoPar External Components and Controls
ENTER MENU
CAUTION
LAMP ADJUST
LAMP ADJUST
LAMP, G22 BASE.
RISK OF FIRE. USE ONLY
DANGER: INTENSE HEAT.
HOUSING TO COOL FOR
15 MINUTES BEFORE RELAMPING.
MSR 700 WATT METAL HALIDE
DISCONNECT FIXTURE AND ALLOW
RELAMP
x2
RELAMP
x2 Neutrik® AC
Data In
Data Thru
Lamp Adjustment Controls
Upper Enclosure Connections
Upper Enclosure -
Houses power supply, ballast, and
provides Data In and Thru, and AC
power connections (see detail below).
Clamp Mount (2) -
Provides attachment point for truss
hooks or other mounting hardware.
Backcap Assembly -
Provides beam adjustment
controls and access to lamp for
replacement (see detail below).
Mega-Claw Truss Hook (2) -
Allows luminaire to be mounted on truss pipe.
(May be replaced with other truss hook types.)
Yoke Assembly -
Houses Master Control Board
(MCB) and Menu Display.
Lens Rotation Assembly -
Mechanism for rotating front lens.
Menu Display -
Used to configure luminaire
DMX address and other
options. Also, provides
status information.
FRONT VIEW
SIDE VIEW
Power Connector
Lamp
Adjust
Screws
BACKCAP REAR VIEW
Yoke Leg Cover -
Protects interior components. (Do not operate with covers removed.)