Male termination connector – PRG AutoPar User Manual 2.1 User Manual
Page 18
10
AUTOPAR
®
WASH LUMINAIRE USER MANUAL
Male Termination Connector
A male XLR termination connector is required at the last luminaire (or "far end of the line")
to prevent signal reflections. Signal reflections may cancel out the signal at certain line
lengths, resulting in errors. The terminator is also necessary for software downloads and
running tests on multiple luminaires.
To construct your own connector, you will need the
following components:
+
5-pin, male XLR connector.
+
Two 1/4W 5% 120 ohm resistors.
Note: A male termination connector is also available as an accessory from PRG. See
Solder resistors across
pins 2 & 3, and 4 & 5
1
2
3
4
5