PRG AutoPar User Manual 2.1 - Manual (Page 26)

18 AUTOPAR ® WASH LUMINAIRE USER MANUAL
MENU SYSTEM
Overview
The menu system is a programmable set of commands used to configure, address, and report status information at
the Menu Display. The system is controlled by four buttons as shown in Figure 3-1.
Figure 3-1: Menu Display Controls
To enter the menu system, press [Menu]. The first level of
functions are referred to as top level functions. Scroll through
the top level functions by pressing [Up] / [Down] arrows. Once
the desired function appears in the display, press [Enter] to
move to the sub function. Once again, press the [Up] / [Down]
arrows to scroll through all sub functions. At any function, press
[Enter] to enter editing mode. Use [Up] / [Down] arrows to
program a value or toggle a setting such as On/Off. Press
[Enter] to store the value or setting. Press [Menu] to move up a
level.
Example: Enable tilt reverse option
Step 1. Press [Enter] to access top level functions.
Step 2. Press [Up] / [Down] arrows to scroll to Dmx menu. Press [Enter].
Step 3. Press [Up] / [Down] arrows to scroll to Rev Tilt option. Press [Enter] to begin edit mode.
Step 4. Press [Down] arrow to toggle setting to Yes.
Step 5. Press [Enter] to set.
MENU ENTER
Address
30
Menu function or value
Changes a value or scrolls
through menu options
Initiates menu system
or returns to top level
Places currently selected
menu into editing mode and
saves any changed settings
Menu Display
MENU ENTER
Fixture
Serial No
123456
Top Level Menu
Sub Level Menus
Status
OK
Figure 3-2: Menu Levels