Troubleshooting guide – PRG AutoPar User Manual 2.1 User Manual
Page 37
AUTOPAR
®
WASH LUMINAIRE USER MANUAL
29
Troubleshooting Guide
The following table provides a list of common failures and possible solutions.
Symptom
Message
Solution(s)
Refer to...
No power to luminaire.
n/a
Ensure power cable is properly connected to Neutrik
input connector.
Ensure power is switched on at source (mains,
disconnect box, etc.)
No DMX512 control.
No Comm
Ensure data cable is connected to DMX In connector.
Ensure DMX512 address setting is correct.
DMX512 control not working
correctly throughout daisy chain.
n/a
Ensure data cables are correctly configured.
Ensure termination connector is installed at last
luminaire in data link.
Erratic control of luminaire(s).
n/a
Ensure termination connector is installed at last
luminaire in data link.
Ensure termination connector is properly configured.
Lamp does not strike at power-up.
n/a
Configure lamp to start at power-up.
Timing Channels not working.
n/a
Ensure Timing Channels are enabled.
Pan mechanism not operating
correctly.
n/a
Ensure yoke leg covers are installed. (Light beams from
adjacent fixtures can affect the optical pan encoder,
causing it to lose track.)
n/a