Setting a starting address, Dmx comm – PRG Best Boy 4000 User Manual User Manual
Page 33
BEST BOY 4000
®
SPOT LUMINAIRE USER MANUAL
25
Setting a Starting Address
The method for setting a DMX starting address is the same whether the luminaire is being controlled by DMX512 or
Ethernet (Art-Net). The only difference is that the Home screen will display the Comm as either "DMX" or "ETH"
depending on the control input.
The DMX starting address is programmed at the Menu Touchscreen.
The luminaire retains its address even if power is
removed.
Note: Refer to your console operating instructions for specific information regarding its addressing requirements.
DMX Comm
The starting address for DMX512 systems can be set from the HOME screen.
To program a starting address:
Step
1. At Home screen, press address number panel.
Step
2. At numeric keypad, enter new starting address and press ENTER.
Figure 2-15: Setting Starting Address (DMX Control)
Note: Refer to
on page 30 for more information about the Menu Touchscreen.
Control Input Type (DMX)