Perfect Aire PASC12000 - Manual (Page 18)

17
Installing Unit in a Casement Window
(Continued)
12. To remove front: (Fig. 10)
Remove the two front retaining screws from
the front frame.
Gently pull the front out and lift up to release
it from the case.
Release the coupler plugs.
NOTE: DO NOT push or pull air directional
louvers.
13. Place the air conditioner in the window
opening.
(Fig. 11)
The air conditioner should sit on the platform
assembly so that the window panel frame, and
the cabinet side channels are against the top and
side window jambs. Side channels should overlap
side window jambs equally.
14. Drill two 9/64 inch diameter pilot holes.
Drill the two pilot holes in the top window jamb in
line with the partially plugged holes in the panel
frame. Secure the panel frame to the window jamb
with two 3/4 inch self-threading screws. If additonal
holding is necessary, two screws may be used on
the sides of the panel frame as well.
15. Drill screw-clearance holes.
Drill two screw-clearance holes in the cabinet side
channels (near bottom) and two 9/64 inch diameter
pilot holes in the side window jambs. Secure the
cabinet side channels to the window jambs with
two 3/4 inch self-threading screws. When doing
this, be careful not to twist the side channel seals
with the screws.
NOTE: Inserting screws will prevent the air conditioner
from being pushed into the room.
16. To replace the front.
First, reconnect the coupler plugs, make the exhaust
control positioned through the front in the proper location.
Then replace the retaining screws that hold the panel in
place. Do not push or pull the front panel louvers.
Fig. 10
Fig. 11
INSTALLATION INSTRUCTIONS (CONTINUED)