Perfect Aire PAWS1 - Manual

THROUGH-THE-WALL AIR CONDITIONER
SLEEVE INSTALLATION INSTRUCTIONS
HOW TO ASSEMBLE THE WALL SLEEVE
SLEEVE HARDWARE
ITEM DESCRIPTION QTY
1 TOP PANEL 1
2 BOTTOM PANEL 1
3
4
5
6
7
8
9
10
LEFT SIDE PANEL
RIGHT SIDE PANEL
FRONT COVER PANEL
REAR COVER PANEL
BRACKET
CLASP FOR SLEEVE
SCREW ST3.9*10
WASHER
1
1
1
1
4
4
28
8
SLEEVE DIMENSION
SLEEVE INSTALLATION
INSTALL THE UNIT
ASSEMBLE THE WALL SLEEVE
Use four screws to fasten the side panels to the bottom panel as shown
below.
NOTE: The arrow marks on the bottom panel indicate the direction of
indoor side
Place the top panel on and fasten with four screws as shown below.
CLASP FOR SLEEVE
Insert the four clasps for the sleeve into the quadrate holes in the side
panels as shown below.
SLEEVE
INSIDE OUTSIDE
WALL
Remove the old air conditioner from the existing wall sleeve and remove
the existing wall sleeve.
Prepare and install the new wall sleeve into the wall opening.
The wall sleeve must be fastened in the wall securely before installing the
new air conditioner.
Keep the cover panels for later use to protect the sleeve from rainy or
windy weather.
To avoid distortion to the front panel of the air conditioner, the sleeve
should be installed at a distance of 4 minimum from heating source.
(e.g.Baseboard heating,radiator.etc.)
After sleeve has been installed, caulk the entire perimeter around exterior
wall opening and sleeve. Use a good grade of caulking compound to seal
all cracks to prevent air and water infiltration.
The rear grill and washer screws should be kept until the air conditioner
is installed.
Insert the louvered rear grill or the expanded rear grill (packed with air
conditioner you purchased) and fasten with 4 washer screws as shown
below.
Expanded rear grill Louvered rear grill
or