Canon BJC-55 - Manual (Page 30)

• Print head flushing. Press and hold down the RESUME button for
over six seconds until the printer beeps three times then release to
start print head flushing. The
POWER lamp flashes during print head
flushing. (☞85)
CHARGE/ERROR lamp
When the printer is off and the AC adapter is connected to the printer
and plugged into the power mains, the
CHARGE/ERROR lamp lights
green and stays on while the battery pack inside the printer is
recharging. After the battery pack is fully charged, this lamp will go off.
When the printer is on, the CHARGE/ERROR lamp lights or flashes
orange when an error occurs. Remove the cause of the error then press
RESUME to resume normal operation. The first time you switch on the
printer, the empty cartridge holder will move to the centre. The
CHARGE/ERROR lamp will light orange and the printer will beep
three times to remind you to install a BJ Cartridge.
■ Installing the battery pack
Follow this procedure to install the battery pack in the printer.
Install only a Canon Li-Ion Battery LB-50 battery pack. You must install
the battery pack and leave it installed in the printer, even if you intend to
use the printer only with the AC adapter. If the battery pack is not
installed when you switch on the printer, the CHARGE/ERROR lamp will
light orange and the printer will beep six times.
1.
Open the front cover.
2.
If you are installing a new battery pack, remove the battery pack
from its package.
28 Chapter 2 Setting Up the Printer