Oakworks DTPM300 - Manual (Page 9)

UP
DOWN
6
DIReCTIOnS fOR USe
CAUTIOn
fOOT COnTROl OPeRATIOnS
The Foot control must remain on the floor. Damage to the table will result if the foot con-
trol is placed under the column. When operating the table’s controls, be sure to observe all
cautions and warnings.
The Oakworks ® Fluoroscopy Table with Trendelenburg positioning offers a variety of positioning
capabilities for diagnostic x-ray imaging and imaging during therapeutic procedures.
DAnGeR
Should the use of this device create a circumstance under which the patient could be overexposed
to ionizing radiation, discontinue use immediately and determine an alternative radiology table or
alternative x-ray generating source to use.
All Oakworks ® Fluoroscopy Tables come complete with one foot control to control height and a hand
control to operate the height and trendelenburg functions of the table.
Operate the Foot control as shown below to raise or lower the height of the table. To increase or
decrease the angle of tilt up to a maximum of 14º on either side, see the Hand Control Operations on
the next page.