Oakworks Clinician - Electric / Hyrdaulic - Manual (Page 12)

10
DIRECTIONS FOR USE
When operating the table’s
controls be sure to observe
all cautions and warnings
given in the manual to pre-
vent injury to both operator
and client.
OPERATING THE MANUAL TOP (IF EQUIPPED)
To Raise the Back Rest:
Raise the back rest by pressing the lever under the head section and lifting up to
the desired height. It is recommended that clients take some of their weight off
the back rest while you lift.
To Lower the Back Rest:
Press the lever under the head section and push the back rest down. Release the
lever and the back rest will stay in place.
To Change Position of the Back Rest Lever:
The back rest lever can be moved to the opposite side of the back rest by remov-
ing the screws and relocating the hand lever to the opposite side of the top into
the four pre-drilled holes.
Do not sit on the elevated
Back Rest or Leg Rest.
CAUTION
DIRECTIONS
FOR
USE
Back Rest
Control
BACK REST
To Raise the Leg Rest:
Raise the leg rest by pulling the handle on the side of the leg section and raise to the
desired height. It is recommended that clients take some of their weight off the leg rest
while you lift.
To Lower the Leg Rest:
Pull the handle on the side of the leg section and push the leg section down. Release the
handle once leg rest is at desired location and the leg section will stay in place.
To Change Position of the Leg Rest Handle:
The leg rest handle can be moved to the opposite side of the table. First, remove the
screws from the handle and replace just the screws. Move handle to the opposite side of
the table. Remove the screws that are there and mount handle.
LEG REST
Leg Rest
Control