Oakworks Clinician - Electric / Hyrdaulic - Manual (Page 10)

8
INSTALLATION
ASSEMBLY & INSTALLATION
The table comes completely assembled and ready to use. Plug the cord into
a functioning outlet that is rated for the table.
Arrange the power cord and foot switch so that they will not create a tripping
hazard. Place the controls in a safe location where they are convenient and
accessible. Keep the controls out of the way of all table mechanisms.
INSTALLATION
If Table Will Not Sit Flat on the Floor:
The table is equipped with Leveler Feet that adjust to level the table on
uneven floors. To adjust the Leveler Feet to suit common floor dif-
ferences you will need to use a 1 /
2
” open-end wrench or an adjustable
wrench. Adjust each leg individually in turn by adjusting the height of
each leveler foot until the unit rests level and steady. This adjustment
will not affect the function of the table.
LEVELING INSTRUCTIONS
The table weighs as much
as 200 lbs.
DO NOT lift or
move the unit without using
proper safely procedures
or equipment.
DO NOT turn
the table on its side for any
reason. To do so could
cause damage to the base
and
will void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not
designed to
hold the weight of the base
and you could damage the
table.
1/2” Open-end Wrench Leveler Foot
When operating the table’s
controls be sure to observe
all cautions and warnings
given in the manual to pre-
vent injury to both operator
and client.
CAUTION
INSTALLATION