Oakworks Antigua - Manual (Page 18)

DIRECTIONS FOR USE
11
DIRECTIONS FOR USE
• Use & Adjustment of the Antigua ™ Arm Rests
DIRECTIONS FOR USE
To remove one or both arm rests just take hold of the base of the arm
rest at the metal frame and somewhere on the cushion. Holding securely,
rotate the arm rest while at the same time pulling slightly away from
the table. You will feel the notched connection slide out as you rotate
the arm rest. When you feel this you can then slide the entire arm rest
out of the connection hole very easily. Store it safely inside the under-
table cabinet until ready for installation.
Re-attach the armrest by sliding the arm rest frame into the hole on the
tabletop and rotating it until you feel the notch slip into place. Push it
in securely and allow the arm rest to rest in the parallel position. This
resets the arm rest in the proper position for the automatic adjustment
feature to be activated.
Do not place excess weight
on the Side Arm Rests. DO
NOT use them in assisting
the client on and off the
Antigua ™ .
Either arm rest can be
repositioned to allow a
client to get on and off the
Antigua ™ easily.
When making adjustments
to the arm rests make
certain that the client’s
arms are away from the
working mechanism.
Do not sit on the Arm Rests.
SIDE ARM RESTS:
( CONT
.
) • Side Arm Rests
(cont.)
IMPORTANT 
Removing the Side Arm Rests
A. hand soak bowl installation
B. hand soak bowl removal
C. Manicure surface installation
If you have purchased the optional manicure arm rest please follow the
same standard installation and removal instructions as above.
OPTIONAL MANICURE ARM RESTS:
A B C
CAUTION