Oakworks Antigua - Manual (Page 11)

INSTALLATION
4
INSTALLATION
INSTALLATION - LEVELING INSTRUCTIONS
The Antigua ™ comes completely assembled and ready to use. Plug the cord
into a functioning outlet that is rated for the table.
Arrange the power cord and control cords so that they will not create a trip-
ping hazard. Place the controls in a safe location where they are convenient
and accessible. Keep the controls out of the way of all table mechanisms.
LEVELING INSTRUCTIONS:
If Table Will Not Sit Flat on the Floor:
The Antigua ™ is equipped with Leveler Feet that adjust to level the table on
uneven floors. To adjust the Leveler Feet to suit common floor differences
you will need to use a 1 /
2
” open-end wrench or an adjustable wrench. Adjust
each leg individually in turn by adjusting the height of each leveler foot until
the unit rests level and steady. This adjustment will not effect the function of
the table. The feet can be adjusted out ¼”.
The table weighs as much
as 200 lbs. DO NOT lift or
move the unit without using
proper safely procedures
or equipment. DO NOT turn
the
Antigua ™ on its side for
any reason. To do so could
cause damage to the base
and will void the warranty.
There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not
designed to
hold the weight of the base
and you could damage the
table.
• Leveling Feet
When operating the
Antigua ™ controls be
sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.
IMPORTANT 
CAUTION
Use 1/2” Open-end
Wrench to adjust
Leveler Foot