beautypg.com

Antigua, Caution, Important – Oakworks Antigua User Manual

Page 12: Foot control, Adjusting height of the table, Daily cycling, Up down

background image

DIRECTIONS FOR USE

5

DIRECTIONS FOR USE

• Adjusting Height of the

Antigua™

using the Foot Control

ADJUSTING HEIGHT OF THE TABLE:

The O

AKWORKS

®

Antigua

comes complete with a multifunctional hand

control that operates the backrest and leg rest positioning functions as

well as a foot control that operates the height. The lifting motor is

equipped with a thermal overload limiter. It has a 10% duty cycle, 2

minutes operating and 18 minutes off

Foot Controls:
Operate the foot control as shown below to raise or lower the height

of the Antigua

. The foot control allows the therapist to adjust the

height function separately from the other functions found on the hand

control whenever needed. When operating the table’s controls, be sure

to follow all cautions and warnings as given in the manual.

When operating the

Antigua™

controls be

sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.

When operating the

Antigua

controls and making

any and all adjustments to the
table, move hands, feet and
controls away from any work-
ing mechanisms of the table.

Children must be supervised
when around this equipment
by a responsible adult. Do not
leave children alone or allow
them to operate the controls.
Do not allow children to crawl
into the cabinet or under the
table.

Antigua™

• Foot Control

DO NOT use the hand
control and the foot control
simultaneously as this can
cause damage to one or
both units.

IMPORTANT

Foot Control (1):

(used only to change height of table)

CAUTION

CAUTION

DAILY CYCLING

The O

AKWORKS

®

Antigua

uses hydraulics and hydraulic fluids to adjust

the table height. Maintaining the quiet operation of your table requires

that you fully cycle your table (up & down) twice per day. Cycling of

the table will maintain the lubrication within the hydraulic cylinders

for continued smooth and quiet operation. When not possible, we rec-

ommend that you cycle the table (up & down) 7 times at least once per

week.

UP

DOWN

To move the table

position higher, press

down on the left side

of the foot control.

To move the table

position lower, press

down on the right side

of the foot control.