MF Digital CD-QuadraPRO (Rev: 08/01/02) - Manual (Page 46)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 QuadraPRO LX Operator’s Guide
Document Revision: 080102
Page 45
Aligning the printer
Please follow the instructions below to align the printer.
• From the main operating screen depicted below:
S E L E C T C O P Y O R C O M P A R E
• Press the “4” key.
S T A R T L O A D E R T E S T E R ?
S T O P = N O S T A R T = Y E S
• Press the Stop/No key.
P R I N T E R A L I G N M E N T ?
S T O P = N O S T A R T = Y E S
• Press the Start/Yes key.
P R E S S S T A R T O R S T O P
P R I N T E R A L I G N M E N T T E S T
• Press the Start/Yes key.
O P E N I N G T R A Y
P R I N T E R A L I G N M E N T
• At this point the automated arm will pick a disc up from the input area
and place it onto the printer tray. Check the alignment of the printer and
adjust the printer accordingly. After the disc has been placed you will
see the following screen:
P R E S S S T A R T T O U N L O A D
P R I N T E R A L I G N M E N T
• Press the Start/Yes key. The disc will be unloaded from the printer tray
and put onto the output spindle. You will be returned to the start of the
test, repeat the process if further alignment is required.
P R E S S S T A R T O R S T O P
P R I N T E R A L I G N M E N T T E S T