MF Digital CD-QuadraPRO (Rev: 08/01/02) - Manual (Page 22)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 QuadraPRO LX Operator’s Guide
Document Revision: 080102
Page 21
T E S T I N G D R I V E S T A T U S
D R I V E 1 D E T E C T E D
• Close the remaining drives in the order that you would like them to
read
T E S T I N G D R I V E S T A T U S
C L O S E D R I V E T R A Y 2
• Press the “8” key on the keypad. The screen will now read:
S E L E C T R E C O R D I N G S P E E D
[ 0 ] = 1 6 X [ 1 ] = 2 4 X [ 2 ] = 4 0 X
The factory setting for this function is “40x”. When selected the
Select Recording Speed feature allows you to set the copying speed
as determined by the capabilities of the recorders installed in the
QuadraPRO.
• Press the “0” key to select 16x, or the “1” key for 24X or the “3” key
for 40X. After pressing any of those keys, the screen will now read:
? ? x R E C O R D I N G S P E E D
S E L E C T C O P Y O R C O M P A R E
• Press the “9” key on the keypad. Something similar to the following
will be displayed in sequence:
I D L E
D E V I C E 1 [ S C S I ( 1 , 1 )
This displays the status of the last disc copied or compared in each of
the QuadraPRO’s recorders. If the last operation performed was
successful, the screen will report “OK”. If problems were
encountered, an error message will be displayed.