MF Digital CD-QuadraPRO (Rev: 08/01/02) - Manual (Page 21)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 QuadraPRO LX Operator’s Guide
Document Revision: 080102
Page 20
If the STOP/NO key is pressed you will be prompted to set the
“System Time.”
S E T S Y S T E M T I M E ?
• Press the START/YES key to set the system time.
If the STOP/NO key is pressed you will be prompted to “Read
Watermark.”
R E A D WA T E R M A R K ?
The watermark is a unique electronic fingerprint. These fingerprints
allow discs to be traced back to the specific unit and even to the
recorder that wrote them. Watermarks are useful ways of dealing
with unauthorized copying, authenticating discs as well as helping to
diagnose copying problems.
• Press the START/YES key to read the watermark..
If the STOP/NO key is pressed you will be prompted to “Read
ATIP.”
R E A D A T I P ?
When selected, the ATIP function allows you to determine the
manufacturer of the CD-R placed in drive 1 of the QuadraPRO.
• If you pressed the Stop/No key at you will be prompted to “Set the
Drive Order”:
S E T D R I V E O R D E R ?
• Press the “Stop/No” key if you do not want to reset the drive order.
Press the “Start/Yes” key and you will then see the following screen:
O P E N I N G D R I V E S . . .
• All of the drives will open at this time:
T E S T I N G D R I V E S T A T U S
C L O S E D R I V E T R A Y 1
• Close the drive tray of the drive you would like to be drive number
“1”. It can be any one of the drives. You will then see the following
screen: