MF Digital CD-QuadraPRO (Rev: 08/01/02) - Manual (Page 23)

CD-3706/P Operator’s Guide
Document Revision: 030501.1 QuadraPRO LX Operator’s Guide
Document Revision: 080102
Page 22
Creating A Hard Disk Image
The QuadraPRO comes equipped with an internal hard disk drive, which
can be used to store copies of master discs for later recording or comparing.
Each master is saved as a single image file. Up to four images can be stored
on the hard disk at one time.
A hard disk image is useful as a convenient way of copying standard master
discs. For example, create hard disk images for three or four master discs
which are needed on a regular basis, and access them to make copies as
required.
Creating A Single Hard Disk Image
Although the QuadraPRO’s internal hard disk can store up to four images
of master discs, it is sometimes prudent not to use this Multiple Image
feature and only allow one image to be created and stored. For example,
using a single image simplifies the copying process. This reduces the
chance that an operator might make copies of the wrong discs by selecting
the incorrect hard disk image.
To create a single hard disk image, the steps are as follows:
• From the main operating screen depicted below:
S E L E C T C O P Y O R C O M P A R E
• Press the COPY key. The screen will now read:
F R O M H D ?
• Press the STOP/NO key. The screen will now read:
C O P Y T O H D ?
• Press the START/YES key. The screen will now read in sequence:
L O A D I N G M A S T E R
G O O D : 0 B A D : 0 O F : 0
WA I T I N G F O R D R I V E S R E A D Y
G O O D : 0 B A D : 0 O F : 0