KERN & SOHN SD 30N70 - Manual (Page 2)

Sauter GmbH
Tieringerstr. 11-15
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9976-174
Fax: +49-[0]7433-9976-285
Internet: www. sauter.eu
Instruction Manual
SD
SD-BA-e-1112 2
PEAK:
Three functions
-
Track mode (continuous measurement)
- Peak mode (capture of maximum values)
- Auto-Peak mode, same as Peak-mode, only
without the „Min limit peak save“ function
MEMORY:
Saves the peak values to calculate the average
value (please see section “Memory mode”
DELETE Function
Deletes stored peak values (only in „Memory
mode“ active)
PRINT:
Sends the stored peak values to a PC or Printer
(please see section „Data Output)
c.
High / Low limit function
LEDs to display OK / NOT OK Tests
▼
Lower than lower limit
OK OK
▲ Higher than higher limit
This function allows efficient testing of OK / NOT OK
measurements of similar or identical testing objects.
A lower and an upper limit value can be defined. The
instrument compares the individual measuring results with
these limit values and shows the OK or NOT OK result by
green or red light diode and by sound.
To set these limit values, please see the SET Menu in
section „Operating keys“.
d.
Measurement (Track Modus)
Display (1) shows the continuous force in a defined
direction (6)
To zero the display, press:
e. Peak-Hold Function (Peak Mode)
Please press:
f.
Auto-Peak-Hold-Function (Auto-Peak Mode)
Please press:
g.
Min limit peak save
This function allows to eliminate unwanted „Pre-Peak
values“ that are lower than the main peak value (Fp). The
“Min limit peak save” value (Fo) takes care, that these
“Pre-Peak values” are not saved.
The „Min limit peak save“ function is only in the Peak-
Mode possible.
To set this Min limit value, please see the SET Menu in
section „Operating keys“.
h. Memory mode and average value (from up to 10
peak values)
Saving peak values in the instrument
Activating the „AUTO PEAK Function“ by PEAK key
Deactivating the „Average Function“ by MEMORY
key
Now, all peak values are stored automatically in the
instrument
To browse through the stored values, please use the
▲ or ▼ keys. (The values will be shown in the upper
display segment)
By pressing the MEMORY key, the average value of
the stored peak values can be shown (in the upper
display segment)
To delete every stored value, press the▼-key in the
AVERAGE-Mode
3. Thread of the fine adjustment screw
The following is valid for small Spring Testers (SD 10,
20,30) and those of medium size (SD 50, 100, 200, 300,
500):