KERN & SOHN FL 2K - Manual (Page 6)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
FL
FL-BA-e-1411 6
11. Measurement practice
For best measurement accuracy keep the
compression/tension forces in line with the force gauge.
Alleviate bending loads and torque loads applied to the
load cell as these can adversely affect measurement
performance.
Always keep the gauge below the capacity limit shown on
the front of the gauge. If gauge is used above this capacity
in either tension or compression, even for a short time,
permanent load cell damage can result. Overload damage
is not covered by warranty.
Accuracy: ± 0.2 % of rated capacity
Operating temperature: 60 ºF - 95 ºF (15 ºC - 35 ºC)
Temperature shift at zero load: ± 0.04 % of full-scale/ºC
Output
RS-232 and USB: 8 data bits, 1 Start bit, 1 Stop bit, no
parity
Baud rate: 38400
Peak Capture Rate : 0.100 S
ADC Sampling Rate : 1,000 Hz
12. Declaration of Conformity