KERN & SOHN FL 2K - Manual (Page 4)

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
FL
FL-BA-e-1411 4
Use UP and DOWN key to move the cursor. Press the
ENTER key to select auto-off option and return to main
menu page.
2) PASS-FAIL
The Pass-Fail feature used to set a defined acceptable
maximum and minimum forces gap for measuring. It is
activated by setting the lower level and upper level forces
limit. If the forces value is within the gap level, the display
will show message PASS. Any reading values outside this
gap (higher or lower), the display will show message FAIL.
If you activate this feature the PF symbol will be shown on
main display.
To access PASS-FAIL menu, Press UP and DOWN to
move the cursor point to PASS-FAIL and press the ENTER
key the display will show the Pass-Fail menu page. Press
ESC key to return to the main menu page.
Figure 6
Use LEFT ARROW keys to move the cursor point to the
desired value.
Use UP and DOWN keys to change the value, press and
hold to scroll values. Use RIGHT ARROW key to change
the unit. Press ENTER to save the settings and return to
main menu page.
*Pass-Fail feature will automatically be disabled if you set
LOWER and UPPER = 0 N.
*LOWER must be less than the UPPER.
Example LOWER LEVEL = 0 N, UPPER LEVEL = 20 N
Example LOWER LEVEL = 10 N, UPPER LEVEL = 20 N
Example LOWER LEVEL = 10 N, UPPER LEVEL = 20 N
3) MEMORY
This is used to view the saved record, delete current
record, delete all record and print data of the saved record.
To access MEMORY menu, go to the main menu page
press UP and DOWN to move the cursor point to
MEMORY and press ENTER key the display will show the
memory page. Press ESC key to return to main menu
page.
Figure 7a Memory Page
Press UP and DOWN to change memory page, press and
hold to scroll change memory page. Press PRINT key to
print the memory to the serial port. Press ZERO key to
access the DELETE menu.
Figure 7b Delete last Menu
Press UP and DOWN to select the delete option. If you
selected NO and press ENTER key, the gauge will return