Keri Systems SM-2000 - Manual (Page 7)

IntelliProx – SM-2000
2305 Bering Drive 01830-003 Rev. H
San Jose, CA 95131 USA
(800) 260-5265 (408) 435-8400 FAX (408) 577-1792
Web: www.kerisys.com E-mail: [email protected]
Page 7 of 10
IntelliPr
o
x
Quick S
tart Guide
8.0 IntelliProx to D-Lite Connections
Communication between the IntelliProx and the D-Lite software is done between the RS-232 serial port in the
IntelliProx and a serial port in the host computer. The most common connection is made through a three-conductor,
shielded cable using a DB-9F connector to connect to the host computer. Some computers might use a DB-25F
connector. Refer to Figures 6 and 7 as appropriate for the computer you are using.
NOTE: Wire colors may be differenet than shown. Always verify pin to pin connections.
Figure 6: IntelliProx to DB-9F Connection
Figure 7: IntelliProx to DB-25F Connection
NOTE: Keri Systems does not supply the IntelliProx to DB-25F cable.