Cisco OL-21851-01 - Manual (Page 18)

5-18
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 5 Configuring and Managing the Cisco Unified IP Phone
Configuring MIDlets
Configuring MIDlets
To use the Enhanced Phone User Interface (MIDlets), your Cisco Unified IP Phone 7970 Series must be
configured to run a new application service. This section explains how to implement the MIDlets
interface, which is available in Cisco TelePresence System (CTS) Release 1.5 and later releases.
The Cisco Unified IP Phone auto-configures the IP address of the CTS. The CTS obtains the phone IP
address using CDP data and CTS sends the command to the Cisco Unified IP Phone to start the MIDlet.
The launch command specifies the IP address of the CTS.
Before You Begin
If you are upgrading from an older XML specification identifier (XSI) user interface to MIDlets, you
must reset the phone and reset the CTS to allow the Java MIDlets application to work with the
Cisco Unified IP Phone. See the
“Managing Phone Reset and Codec Connectivity” section on page 4-7
for reset information.
Minimum Ring Volume Yes 0-Silent.
Additional drop-down menu
choices:
• 2 through 15.
Controls the minimum ring volume on an IP phone.
This value is set by the administrator, and can not be
changed by an end user. The end user can increase
the ring volume, but may not decrease the ring
volume below the level defined. The minimum ring
volume range is from 0 to 15, with 0 (silent) being
the default value.
HTTPS Server Yes HTTP and HTTPS Enabled. Allows the administrator to permit HTTP and
HTTPS or HTTPS-only connections if Web Access
is enabled.
Handset/Headset Monitor — Disabled. When handset/headset monitoring is enabled, a
supervisor can pick up the inactive handset/headset
and hear the call in progress. For example, if an
agent is on a call on the headset, a supervisor can
hear the other party on the handset. Only the
microphone on the active handset/headset is in use.
For example, if an agent is active on the headset,
then the headset microphone is active and the
handset microphone is disabled.
Enbloc Dialing — Enabled. —
Switch Port Remote
Configuration Yes Disabled. —
PC Port Remote
Configuration Yes Disabled. —
Automatic Port
Synchronization Yes Disabled. —
SSH Access Yes Disabled. —
80-bit SRTCP Yes Disabled. —
Table 5-9 Product Specific Configuration Layout Fields (continued)
Field Required? Setting Description