Expansion module information, External data locations information – Cisco OL-21851-01 User Manual
Page 8

5-8
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 5 Configuring and Managing the Cisco Unified IP Phone
Configuring the Cisco Unified IP Phone
Expansion Module Information
describes fields found in the Expansion Module Information section on the Phone
Configuration page. Leave all fields unchanged.
External Data Locations Information
Define the server locations for external data using the information in the following sections as a guide:
•
External Data Location Settings for CTS Release 1.7 and Later
Note
Observe the Following—The server designation can be either the IP address or the hostname of the
Cisco TelePresence device that is associated with this phone.
If a server hostname is used, it must be resolvable by the Cisco Unified IP Phone 7970 Series
DNS
.
•
The format for each required field is http://server hostname: or IP address: Followed by the 8080
port address, then a slash and one of the following, depending on the field:
–
services.html
–
getservicesmenu.jsp
–
authenticate.html - For CTS release 1.6 systems with MIDlets and earlier (only allowable
option)
–
idle.html
•
Leave fields in the External Data Locations Information table blank to use the default settings.
Table 5-3
CAPF Settings
Field
Required?
Setting
Certificate Operation
Yes
No Pending Operation.
Authentication Mode
Yes
Leave this field unchanged.
Authentication String
—
Key Size (Bits)
Yes
Operation Completes By
Optional
Certificate Operation Status
—
Note
Security Profile Contains Additional CAPF Settings. See the
“Phone Security Profile CAPF
Information” section on page 1-11
.
Table 5-4
Expansion Module Information
Field
Required?
Setting
Module 1
—
Module 1 Load Name
—
Leave blank.
Module 2
—
Module 2 Load Name
—
Leave blank.