Configuring the cisco unified ip phone, Adding a new phone – Cisco OL-21851-01 User Manual
Page 2
5-2
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 5 Configuring and Managing the Cisco Unified IP Phone
Configuring the Cisco Unified IP Phone
Adding a New Phone with MIDlets Capability
If you are using Unified CM release 8.0 and wish to enable
MIDlets
features on new phone installations,
you must first enable Web Access. Web Access is not enabled by default; it must be enabled manually
in the Web Access field of the
Product Specific Configuration Layout
window.
Configuring the Cisco Unified IP Phone
Use the information in this section to perform the following tasks:
•
•
Managing Cisco Unified IP Phones, page 5-3
Note
The Cisco Unified IP Phone is connected to the Cisco TelePresence device with an Ethernet cable. See
the cabling chapters in the Cisco TelePresence Assembly guides for more detailed cabling instructions.
Go to the Cisco Support Pages to find installation documentation for your Cisco TelePresence System:
Cisco TelePresence System
Adding a New Phone
To add a new phone:
Step 1
Log in to the Cisco Unified CM Administration interface.
Step 2
From the Device drop-down menu, choose Phone. The Find and List Phones Page appears.
Step 3
Choose the type of Cisco Unified IP Phone you have (Cisco 7970, Cisco 7971, or Cisco 7975) from the
Phone Type drop-down menu.
Step 4
Click Next. The Phone Configuration window appears.
Step 5
Choose SIP from the Select the Device Protocol drop-down menu.
Step 6
Click Next. The Phone Configuration window is updated with the following configuration fields:
•
•
•
Certification Authority Proxy Function (CAPF) Information
•
•
External Data Locations Information
•
•
•
•
•
Product Specific Configuration Layout
Step 7
Proceed to
“Managing Cisco Unified IP Phones” section on page 5-3
to configure the fields found in the
Phone Configuration window.