Citizen Systems Citizen CLP 8301 CLP-8301 - Manual (Page 63)

Chapter 6 Configuring Your Printer Using the Menus
− 50 −
Group Menu Menu Item Default Value Range of Values Description
Tear Mode Off Off
On Set Tear Mode.
Paper Position 0.00in
0.0mm When Tear Mode is On
- 1.00
−
1.00in
- 25.4
−
25.4mm
When Tear Mode is Off
0.00
−
2.00in
0.0
−
50.8mm
Adjust the tear off position when media
is fed from the printer after performing
tear off operation. This adjustment is
performed if necessary.
* After Print
Repeat Button LastOne LabelSet
LastOne
Disabled elect repeat printing method.
LabelSet: Reprint the number of
duplications that are set in the label
format.
LastOne: Reprint the last label from the
most recently printed batch. (One Label)
Disabled: Disable Repeat key.
RS-232C Baud 115200 115200
600
1200
2400
4800
9600
14400
19200
38400
57600 Set serial interface baud rate.
New value is valid after power is turned
off and on gain or a reset command is
issued.
RS-232C Parity None None
Odd
Even Set serial interface communication
parity.
RS-232C Length 8 bits 8 bits
7 bits Set serial interface character length.
RS-232C Stop bit 1 bit 1 bit
2 bits Set serial interface stop bits.
RS-232C X-ON Yes No
Yes Enable or disable serial interface X-ON
flow control.
Network Address 000.000.
000.000 000.000.000.000
−
255.255.255.255
Set network IP address.
Subnet Mask 000.000.
000.000 000.000.000.000
−
255.255.255.255
Set subnet mask.
* Interface
Gateway Address 000.000.
000.000 000.000.000.000
−
255.255.255.255
Set gateway address.
* Save Settings
  
Permanently save configuration values
in non-volatile memory.
Print Pattern Current
setting Current setting
Machine Info
Pattern Slanting
Pattern Sample Choose and execute a test print.
The test pattern or configuration print
can only be produced when there is no
print job is in buffer.
Head Check No Yes
No LCD display shows the number of faulty
element(s) on the printhead, when Yes
is selected.
Factory Default No Yes
No Return to factory default setting values.
* Test Mode
Hex Dump No Yes
No Data sent from host PC is printed as
HEX dump data for checking the
software program when Yes is selected.