Culligan Aqua-Cleer Advanced Drinking Water Systems - Manual (Page 24)

24
AS3
The AS has been tested according to NSF/ANSI 5 for the reduction of the substances
listed below. The concentration of the indicated substances in the water entering the
system was reduced to a concentration less than or equal to the permissible limit for water
leaving the system, as specified in NSF/ANSI 5. Conforms to NSF/ANSI Standard 5 for
arsenic (trivalent and pentavalent) reduction. See Arsenic Fact section for an explanation
of reduction performance.
Substance Influent
Challenge
Concentration
mg/L
Maximum
Permissible
Product
water Con-
centration
mg/L
Reduction
Require-
ments
Minimum
Reduction
Average
Reduction
Standard 5
Trivalent Arsenic pH 6.5 0.050 + 10%
0.010 94.9%
Trivalent Arsenic pH 8.5 0.050 + 10% 0.010 98.0%
Pentavalent Arsenic 0.050 + 10% 0.010 97.4%
Flow Rate = 0.05 gpm (0.1 Lpm)
Capacity = 1000 gallons (786 L)
1000 gallon capacity is only for use with PID
Testing was performed under standard laboratory conditions, actual performance may vary
Performance
Data Sheet
(con’t)