Avaya C360 - Manual (Page 162)

Avaya C360 Layer 3 Features
162 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
IP Configuration
IP Configuration CLI Commands
In order to... Use the following command...
Enable IP routing ip routing
Set ICMP error messages ip icmp-errors
Specify the format of netmasks
in the show command output ip netmask-format
Create and/or enter the
Interface Configuration Mode interface
Assign an IP address and mask
to an interface ip address
Set the administrative state of
an IP interface ip admin-state
Update the interface broadcast
address ip broadcast-address
Define a default gateway
(router) ip default-gateway
Define the interface RIP route
metric value default-metric
Enable net-directed broadcast
forwarding ip directed-broadcast
Set the IP routing mode of the
interface ip routing-mode
Enable or disable the sending of
redirect messages on the
interface ip redirect
Check host reachability and
network connectivity ping
Trace route utility traceroute
Create a router Layer 2 interface set vlan (Layer 3)
1 of 2