Cabletron Systems SmartSTACK 100 - Manual (Page 49)

Configuring Your ELS100-16TX
3-3
• Class B addresses are used for medium sized networks. The first
two bytes identify the network and the last two identify the
node. The first byte of a class B address must be in the range
128–191. The address 128.150.50.10 identifies node 50.10 on
network 128.150.
• Class C addresses are used for small networks. The first three
bytes identify the network and the last byte identifies the node.
The first byte of a class C address must be in the range 192–223.
The address 192.138.217.10 identifies node 10 on network
192.138.217.
To assign an IP address to a port, at the LCM prompt:
1. Type ipaddr
For example, ipaddr 6 192.138.217.40 would set the IP address of
Port 6 to 192.138.217.40. LCM responds by displaying the IP address
table, as shown under the
ipaddr command.