Cabletron Systems SmartSTACK 100 - Manual (Page 26)

1-16
Introduction
Figure 1-6 shows two Ethernet segments that take advantage of the
virtual workgroup feature of the SmartSTACK 100 ELS100-16TX
and the increased bandwidth applied to each A and B host.
Figure 1-6. Using the SmartSTACK 100 ELS100-16TX to Create Virtual
Workgroups to Help Optimize Bandwidth
A host from workgroup A can limit a broadcast to all hosts within
workgroup A and prevent the broadcast from going across the
network and adding to the amount of contention for the limited
100 Mbps bandwidth.
Ports that are not part of a workgroup will receive and transmit
packets from any ports. However, if you configure the
SmartSTACK 100 ELS100-16TX with workgroup A and B, as
shown in Figure 1-6, broadcast traffic from workgroup A ports will
not be seen on workgroup B ports, and vice versa.
PWR CPU RESET COM
PORT STATUS MODE TX ACT FDX MON
RX COL 100 USR
STATUS
ELS100-16TX EPIM100
EPIM100
10X 12X 14X 16X
9X 11X 13X 15X
2X 4X 6X 8x
1X 3X 5X 7X LINK STATUS LINK STATUS 2 4 6 8 10 12 14 16
1 3 5 7 9 11 13 15
ELS100-16TX
Router
A A A B B B
A B
Workgroup A Workgroup B
A A B B